Friday, February 5, 2010

Where Does The Gas Line Plug In On A Yerf Dog Go Kart I'm Installing A Gas Dryer In A Newly Built Home And The Gas Line From The Wall Seems To Have A Plug In It?

I'm installing a gas dryer in a newly built home and the gas line from the wall seems to have a plug in it? - where does the gas line plug in on a yerf dog go kart

Directly below the op made it seem to be threaded cap on the track. There is no way to connect to my line, and it is so strong that one can hardly move, I can delete?

7 comments:

grainy33 said...

Payfor someone else.
If the plug is under the valve to ensure that the valve is turned off. The power supply is probably a place in the final.
Slowly unscrew it. When you hear, smell, or gas, turn off the tap until it stops.
The stopper and connect the hose to your beautiful and removing crank it down so that it can never be eliminated. Check Check for leaks. You can with soapy water or a Canary lol. I do not recommend a small, but I have seen, have made it

Applianc... said...

The ceiling was all accidental release of gas into the house of someone, the valve shall set or turn the valve. Remove the cap after he is satisfied that the valve is turned off. All joints must be sealed with Teflon tape or pipe dope while and then tested with soap bubbles.

mel said...

If these fears, a plumber to connect to your seat. Cost is always worth good.

oldbeeme... said...

The plug is to prevent it open to the exhaust pipe when you need the appropriate assessment not try to change it. DIY work on gas supply could cause all insurance claims if something goes wrong. My advice to a professional to do the job. Peace of mind is worth the effort.

michael g said...

Two buttons, decent size (12 ", 14") as influences. Enter make the installation screwed into place, in accordance with the strengthening of key equipment and other relaxation of the cap. Remember: Lefty loosely whiti intelligent. Use some elbow grease, and many regrets. There was never a meeting that could not solve.

michael g said...

Two buttons, decent size (12 ", 14") as influences. Enter make the installation screwed into place, in accordance with the strengthening of key equipment and other relaxation of the cap. Remember: Lefty loosely whiti intelligent. Use some elbow grease, and many regrets. There was never a meeting that could not solve.

jdris52@... said...

If the plug closely to try to remove the valve to cut too much and its replacement by a new one. Make sure you wrap the threads with Teflon tape for gas lines.It "Type S yellow.

Post a Comment